Click on "APPLY" button to enable the setting.

Note:

Web Control cannot be used while Rename setting is being applied. (About 30 sec.)

Web Control cannot be used while Rename settings are being applied. (About 30 sec.)

Network Name : It allows strings between 1 to 15 characters long.

Zone Name : It allows strings between 1 to 9 characters long.

Click on "APPLY" button to enable the setting.

Note:

After the setting is enabled, IP address will be changed,

and the browser may become inoperable.

To continue with an operation,

the browser needs to be restarted with changed IP address.

IP address can be set with main unit's Setup Menu.

Click on "APPLY" button to enable the MAC address filter.

Note:

Any device with a MAC address not listed above will be denied access

to the receiver.

MAC address filter can only be disabled in the Setup Menu.

This setting is not stored in receiver.

"On" will display current receiver status every 5 seconds.

"Off" will not automatically display current receiver status.

Note:

To display the status at any time click the "RELOAD" button

in the bottom right hand corner of the window.

The desired zoom setting will be applied after rotating the iPhone display.

This setting is not stored in receiver.

Any setting other than default may result in slower page rendering.

[Parameters]
Parameter settings can be entered by editing the URL in the browser:
Insert first parameter after "?" character
Insert multiple parameters using "&" character

Example: http://192.168.0.1/index.html?topmenu=0&zone=1
In this example, the Top Menu button will not be displayed
on the Main control page.

Any combination of the following parameters can be used:
topmenu = 0(no top menu)[default] / 1(On)
zone = 0(TopMenu)[default] / 1(Main) / 2(Zone2) ...
reload = 1(On)[default] / 0(Off)
settings = 1(On)[default] / 0(no settings button)

When entering the receiver's MAC address, make sure to enter a colon ":"

between each set of digits. The format should be "00:00:00:00:00:00"

The desired zone must be powered on before attempting to control.

If the zone is not powered on, all settings will be ignored.

The Web Control interface can be customized to display only the desired

control options. Use the checkboxes below to select the desired controls,

and click "Create Link" to generate a new web page. The page can then be

bookmarked for future access.

This option allows the receiver to be powered on via Web Control.

This setting is stored in receiver.

"On" : Enables the network standby function.

"Off" : Disables the network standby function.

Save the current setting of this Unit.

Restores settings for this unit that have been saved.

Click on "START" button to start the firmware update

by using the update file stored in a PC.

And wait for 30 seconds to move on to the firmware update page.

Note:

Firmware update may take about 20 minutes.

Don't turn off the power during the update.